In order to make the large and medium-sized reduction electric furnaces of ferroalloy run better, it is required that the burden has proper fragmentation and ensures good air permeability. At present, the supply of high-quality lump burden which can be directly fed into the furnace is becoming increasingly tight. In order to adapt to this situation, some manufacturers at home and abroad have adopted various lump technologies to effectively utilize fine ore and concentrate and obtained better smelting indexes.

According to the different subsequent smelting processes, vanadium-titanium iron concentrate pellets determine their respective application fields. Vanadium-titanium iron concentrate acid oxidation pellets are mainly used in blast furnace smelting, blast furnace burden protection and gas-based shaft furnace reduction, but vanadium-titanium iron concentrate carbon pellets are mainly used in coal-based direct reduction.

According to comprehensive analysis, LT dust can be reused while reducing environmental pollution by returning to converter for smelting after being lumped nearby, which is the best choice for its utilization mode.

Dust removal methods in the converter steelmaking process can be divided into the wet method and dry method. The traditional wet purification system is as follows: after the flue gas is treated by water spraying, the smoke dust is removed, and the sewage with smoke dust is treated by separation, concentration, and dehydration to obtain converter sludge, and the purified gas is recycled.

The tunnel kiln process is relatively simple, the technical content is low, and the raw materials, reducing agents, and fuels are easy to solve. The process has strong practicability, small early investment, and is suitable for small-scale production. It is a metallurgical reduction production process commonly used in the powder metallurgy industry.

Gas-based direct reduction iron (DRI), which has been commercialized, is made from natural gas or coal. In recent years, with the global attention to carbon dioxide emissions, active research has been carried out on the low carbonization of DRI processes, mainly carbon dioxide removal in existing commercial DRI processes or the use of renewable energy to produce reducing gas.

SSC800 classification crusher consists of: 1. frame, 2.motor, 3.torque-limited hydraulic coupling, 4.reducer, 5.coupling, 6.bearing seat, 7.side plate, 8.crushing roller, 9.ubricating oil pump and 10.traveling mechanism.

Solid preparations of solid beverages, health food and drugs all need to mix the components of solid powder. The proportion of components in the formula can reach 80%-90%, and the proportion of components is less than 1%. The forms are powdery, granular and flaky.

The production of calcium magnesium phosphate fertilizer by blast furnace method has certain requirements on the particle size of phosphate rock and flux entering the furnace. Screening off fine ore less than 10mm is one of the important prerequisites for smooth operation, high yield, stable yield and low consumption of blast furnace. However, at present, the content of fine ore in the raw phosphate ore is as high as 20-40%, so the treatment of fine ore has become an urgent problem to be solved in the current phosphate fertilizer plant.

HPS mixed pellet sintering belongs to the small pellet sintering process, which is to mix iron ore powder, returned ore, flux and fuel with water to make small balls with a diameter of 5-10mm, wrap a certain proportion of solid fuel on the surface of the small balls, and then sinter. Compared with the common sintering method, the small pellet sintering method has increased the process links of strengthening granulation and rolling pulverized coal outward.